Break Disk front for Kawasaki VN800, VN900, VN1600, VN1700, VN2000

Front Brake disc, rigid design

The aim of the development is to improve the braking behavior compared to the original brake disc. EBC uses HPSR steel with a low carbon content, which has an 18% higher friction coefficient. This steel is significantly more resistant to rust than cast steel. In addition, the entire surface is protected by a 3 micron thick zinc layer, which is already abraded in the area of ​​the brake lining contact zone when braking. It is only in this area that it is easier to form rust rust with a longer service life.

- Brake ring made of forged HPSR steel with low carbon content.

- Therefore there is no warping of the brake disc even at the highest load.

- No glazing of the braking surface, therefore the coefficient of friction remains constant.

- Braked surface with optimized hole pattern.

- Galvanized to protect against corrosion.

- Lowest manufacturing tolerances.

- EBC recommends for best braking performance EBC Double-H sintered brake pads.

- Stand-alone design.   

Ask question

Fits for