Axel Joost electronic box version D
This control box is probably the most flexible box on the market. It controls all the main functions on the motorcycle. The following options are possible:
- Integrated flasher relay, controllable via pushbuttons or with switches
- Output for flashing control available
- 2 inputs for side stand - and neutral switch are implemented
- Adjustable turn signal reset and limiting light function of the turn signals (position light)
- An output for the flashing control - LED in the speedometer is integrated. This saves additional wiring effort.
- Control of high and low beam via pushbutton or switch
- Control of horn via pushbutton
- Control of brake light
- Control LED's on the outputs for easier monitoring of the functions
- Automatic detection of an optionally available handlebar adapter in button mode. You can find a handlebar adapter under \Accessories\.
By the way, the new D-Box can also be controlled with only 2 buttons. Therefore, no key combinations need to be memorized by the user:
- A short press on one of the two buttons switches on the respective turn signal. A further short press on one of the two buttons switches it off again.
- A slightly longer press and hold (over about 0.3 seconds) left switches the horn.
- A slightly longer press and hold (for about 0.3 seconds) right switches the starter.
- Two short button presses on the left side switch between high and low beam.
- Two short button presses on the right side switch the ignition on - or off.
- A short press on both buttons at the same time switches on the hazard warning lights function.
- The individual outputs are of course short-circuit proof and self-resetting after a short circuit.
By the way, the D-Box can also be used for Harley Davidson motorcycles with a TSM/TSSM module to control the TSM/TSSM module. A combination with the existing alarm system is thus possible without further ado. For this, the D-Box supplies a constant voltage to the turn signal outputs when the turn signals are activated.
Dimensions: 50 mm length x 12.5 mm width x 42 mm height
Current consumption: maximum 7mA at 12V
Housing: black impact-resistant ABS plastic, waterproof encapsulated
Input voltage: 6 - 18 volts
Connections: Control section 0.14mm², power section 0.75 mm², 1.5 mm² for supply cable, 15 cm each
Maximum output current: 5 amps light, 3 amps for the other outputs, current limit at 5 amps
Maximum ambient temperature: 80 degrees Celsius
Allowable current from 12V connection: 20 amps
Supplied: 1 piece
Tip:
If you have any questions about the appropriate box, you can use the table, or the following interactive video: https://www.youtube.com/watch?v=nietDWvNRro
You can find a short video on how to set up the box here: https://youtu.be/P8NdlLaev_Q
NOTE:
Replaces items 361-925 and 361-984.